User's Manual

3
4-2 Switching the channel:
When triggered, switch the channel knob instantly.
The PIR Camera will have a 10 seconds delay
before the channel is shifted.
Note: When triggered, if you switch the channel
knob after 5 seconds, then you need to wait for 5
seconds before shifting to other channel.
TROUBLESHOOTING
Status Possible Cause Remedy
1. The Receiver
does not work
a. Poor connection
b. Power on/off SW
not turned on
c. Buzzer/Light SW
not set in right
position
a. Check all
connections are
secure.
b. Turn on power
on/off SW
c. Refer to the
following:
ON: When
triggered, buzzer
sounds two beeps
and trigger LED
flash
Buzzer off: When
triggered, buzzer is
silent and trigger
LED flash
Off: When
triggered,
completely off
2. No image/sound a. Different channel
b. Incorrect
connection
between A/V
connector and
TV
a. Set the same
channel
b. Plug A/V
connector into
matching outlet
3. The Receiver not
triggered
a. The Receiver’s
Buzzer/Light SW
at “OFF”
b. Different channel
a. Set the
Receiver’s
Buzzer/Light SW
at “ON” or
Buzzer Off
b. Set the same
channel
4. VCR Controller
(option) cannot
record
automatically
a. Poor connection
b. Improper
operation
a. Check all
connections are
secure
b. Refer to the VCR
Controller
operating
manual
SPECIFICATIONS
Model CC425 (Transmitter)
Camera Type Color
TV System PAL/NTSC
Resolution (TV lines) 250
Pixel Array (H x V) PAL: 628 x 582
NTSC: 510 x 492
Auto Exposure Up to 1/15000 sec.
Lens f=6.0mm F=2.0
Lens Angle 46°, Diagonal
Sensitivity <5 Lux @F 2.0
Camera Angle 90° horizontally
45° downward
Microphone Built-in
Transmitting Frequency 2400-2483 MHz
(for 4 channels)
Channel Switch 4 positions for 1~4
selection
PIR Detection
Distance/Angle
6m/100° (under 28°C)
Power Adaptor (American)
(European)
AC120V/DC9V, 500mA
AC230V/DC9V, 500mA
Receiver CA117
Operating Frequency 2400-2483 MHz
(for 4 channels)
Channel Switch 4 positions for 1~4
selection
Buzzer & Light Switch 3 positions for buzzer &
light on / buzzer off / off
Power Switch 2 positions for power on/off
Triggered Buzzer & Light
function
Built-in
Power Adaptor 12VDC, 500mA
Connector 1 x RJ-45 for VCR
Controller
1 x DC Jack for Power
3 x RCA Jack for triggered
(red), audio (white), video
(yellow)
FCC CAUTION
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by
the party responsible for compliance could void the
authority to operate equipment.