User's Manual

Inside View of Control Panel
SETTING THE CONTROL PANEL HOUSE
CODE
With unit in Standby mode (power LED only
illuminated).
1. Press
, ,
to put the system into Programming mode.
‘1. USER SETUP’ will be displayed.
2. Use the and buttons to scroll
through the menu until ‘2. SYSTEM SETUP’
is displayed.
Press and ‘2-1 Learn House Code’ will be
displayed.
Press again to set the Control Panel to
receive the House code. ‘DIP SW 12345678 & H
Code: xxxxxxxx’ will be displayed.
3. With the required House Code already configured
on the Remote Control, press the button on
the Remote Control.
When the Control Panel receives the signal from
the Remote Control the Display will change to
show the received house code on lower line of the
8
display beneath the corresponding DIP switch
numbers (1-8).
4. Press , , to return to
Standby mode.
TESTING THE CONTROL PANEL &
REMOTE CONTROL
1. Press
, ,
to put the system into Test mode.
‘TEST MODE – WALK TEST’ will be displayed.
2. Press to activate Walk Test.
‘ Walk Test Waiting…’ will be displayed.
3. Press the ‘ARM’ button on the Remote Control.
As the key is pressed the Control Panel will beep
and the type of the device and button will be
shown on the display.
Press the other buttons on the Remote Control in
turn, as each button is pressed the Control Panel
will beep and show the button being pressed on
the display.
4. Test the range of the Remote Control by pressing
the ‘DISARM’ button on the Remote Control from in
and around the property and from all locations
Upper Keyhole
Fixing Hole
-ve Terminal
(Black Lead)
(Blue Lead)
+ve Terminal
Link P1
Reset Jumper
Power Supply
Jack Socket
-ve Terminal
(Blue Lead)
(Red Lead)
+ve Terminal
External Tamper
Switch Jumper
Fixing Hole
Upper Keyhold
Lower Fixing
Hole
Link P51
Terminal Block