User's Manual

This offers the flexibility of removing or changing
siren’s battery. Wait for 10 seconds until ON/OFF
duration has elapsed, then go ahead with fixing the
siren as desired.
VOICE DIALER TEST
Scroll through the top level Test Mode menu until
‘VOICE DIALER TEST’ is displayed and press
.
In order to test the voice dialer properly, the
prerequisite is to set the telephone number, record the
message and enable the call routing in the
programming mode.
When testing is in progress, simply press to
stop testing.
If ‘LINE STATUS’ LED is flashing, it implies bad
telephone line connection or telephone network being
out of order. Check the telephone line and re-test it.
DIGITAL DIALER TEST
Scroll through the top level Test Mode menu until
‘DIGITAL DIALER TEST’ is displayed and press
.
In order to test the digital dialer properly, the
prerequisite is to set the telephone number and unit ID
number in the programming mode.
When testing is in progress, simply press to
stop testing.
If ‘LINE STATUS’ LED is flashing, it implies two causes
of failure. One is bad telephone line connection or
telephone network being out of order. The other cause
of failure is derived from the central monitoring station.
Consult with the central monitoring station for help.
DEFAULT SETTINGS
User Setup
Users 1-6: Not programmed
Master Password 1234
16
System Setup
House Code 10101010
Alarm Time ON, 180s
Wirefree Siren ON
RF Jamming Detection OFF
Back Light 10s
Alarm Relay On Until Disarm
Zone Lockout ON
Remote Phone Control ON
Rings to Answer Phone 6
Call Abort OFF
Dial method Tone/DTMF
Dialer Mode Voice Dialer
Time 12:00:00
Date 01/01/03
Zone Setup (Z1-10)
Name No Name
Type Intruder
Final Exit OFF
Chime OFF
Entry Delay Zone 1
Zone 2-10
ON, 30s
OFF
Part-Arm 1 OFF
Part-Arm 2 OFF
Walk Through OFF
Voice Dialer Setup
Phone Numbers Not programmed
Message Play Time 70s
Alarm Messages Not programmed
Call Routing All numbers disabled
Call Confirms 1
Call Attempts 3
Full Arm Setup
Exit Delay ON, 30s
Entry Delay Beep ON
Exit Delay Beep ON
Part-Arm 1 Setup
Exit Delay ON, 30s
Entry Delay Beep ON
Exit Delay Beep ON