User's Manual

Part-Arm 2 Setup

Exit Delay ON, 30s

Entry Delay Beep ON

Exit Delay Beep ON

Latchkey Setup

Status OFF

Selected User Setup OFF (all users)

Phone Numbers Not programmed

Home Control Setup

House Code A

Unit 1-8 Setup(Unit Code) 01-08

Alarm Trigger OFF

Answer Phone Setup

Status OFF

Greeting Message Not programmed

Digital Dialer Setup

Phone No. Not programmed

Unit ID No. Not programmed

Call Attempts 3

Open/Close by user OFF

RESET FACTORY DEFAULT

1. Press

User Password

to place the system in Test Mode.

2. Undo the Control Panel cover fixing screws and

open the cover.

3. Switch OFF the mains supply to the plug-in PSU

Adaptor and remove the plug from the DC power

socket in the Control Panel.

4. Remove either back-up battery and disconnect the

battery leads.

5. Set jumper link P1 to the ON position.

6. Reconnect the battery leads and replace the

back-up battery in position.

Reconnect the PSU Adaptor plug to the DC power

socket in the Control Panel and switch On the

supply to the PSU Adaptor.

7. As the Control Panel powers-up, ‘EEPROM RESET’

will be displayed while the factory default conditions

are restored to memory. Once the memory reset

has been completed ‘DISARM READY’ will be

displayed. The Control Panel will now be

reconfigured with all factory default settings.

8. Reset jumper link P1 into the OFF position.

9. Close the Control Panel cover and refit the fixing

screws.