User's Manual

PROGRAMMING INSTRUCTIONS
With the system in Standby Mode.
Press ,
Master Password
The system is now in the Programming Mode
Use the and buttons to scroll through
the programming menu. Press to select the
displayed programming function or sub-menu.
Note: After programming all required functions press
to leave Programming mode and return to
Standby.
USER SETUP
Scroll through the top level programming menu until ‘1.
USER SETUP’ is displayed and press .
Use the and buttons to scroll through
the menu until the required user to be configured is
displayed and press .
Note: After configuring all required users press
to return to the top level programming menu.
USERS 1-6
Default setting: not programmed
Scroll through the menu until the required User to be
configured is displayed and press .
User Password
Scroll through the menu until ‘:1 Password’ is
displayed. The current setting will also be
displayed.
To change the setting press
18
Enter the new 4 digit Password and then
Press to save and exit, or
Press to exit without saving.
Record User Message
This enables each User to record a short 4s message
for use with the latchkey facility. e.g. “system disarmed
by User-1”.
Scroll through the menu until ‘:2 Record User
Message’ is displayed.
To record a new message press .
Press to start the voice recorder, (max.
duration: 4s) Once completed the recording will
automatically be played back, or
Press to exit without changing.
Note: After recording the message, press to
stop the recorder and cancel any remaining
message time.
PROGRAM MODE
Code:
1. USER SETUP
1-1 USER 1 SETUP
:1 Password
xxxx
Enter Password
Code:
:2 Record
User Message
Start…
Yes
->
＊
No
->
＃
:3 Replay
User Message
1-7 MASTER USER
SETUP
:1 Password
1234
Enter Password
Code:
User 2 User 3 Use
r
4 User 5 User 6