User's Manual

Default setting: 3
Scroll through the menu until ‘4-7 Call Attempts’ is
displayed. The current settings will also be displayed.
To change the setting press .
Enter the required number (1-5).
Press to save and exit, or
Press to exit without saving.
ARM STATUS SETUP
Scroll through the programming menu until ‘5. ARM
STATUS SETUP’ is displayed and press .
Note: After configuring Arm Status press to
return to the top level programming menu.
FULL ARM SETUP
Scroll through the menu until ‘5-1 FULL ARM SETUP’
is displayed and press
EXIT DELAY
Scroll through the menu until ‘:1 EXIT DELAY’ is
displayed. The current settings will also be displayed.
To change the settings press .
On/Off Status
Default setting: ON
28
Scroll through the menu until ‘:1-1 Status’ is displayed.
The current setting will also be displayed.
To change the settings press .
Press to enable the Exit delay, or
Press to disable the Exit delay.
Delay Period
Default setting: 30s
Scroll through the menu until ‘:1-2 Delay Time’ is
displayed. The current settings will also be displayed.
To change the settings press .
Enter the required delay period (10 to 250s).
Press to save and exit, or
Press to exit without saving.
Press to return to top level Arm Status Setup
menu.
ENTRY DELAY BEEP
This controls the warning beep which operates during
the Entry Delay period when Full Arm is active.
Default setting: ON
Scroll through the menu until ‘:2 Entry Delay Beep’ is
displayed. The current setting will also be displayed.
To change the setting press .
Press to enable the entry-delay beep, or
Press to disable the entry-delay beep.
EXIT DELAY BEEP
This controls the warning beep which operates during
the Exit Delay period when Full Arm is initiated.
Default setting: ON
Scroll through the menu until ‘:3 Exit Delay Beep’ is
displayed. The current setting will also be displayed.
To change the setting press .
:3 Exit Delay
Beep: xxx
:2 Entry Delay
Beep: xxx
:1 EXIT DELAY
XX XXX
5. ARM STATUS
SETUP
PROGRAM MODE
Code:
:1-2 Delay Time
Enter (10
-
250s)
Select
ON
->
＊
OFF
->
＃
Select
ON
->
＊
OFF
->
＃
Enter (10-250s)
:1-1 Status
xx
Select
ON
->
＊
OFF
->
＃
5-1 FULL ARM
SETUP