User's Manual

Scroll through the programming menu until ‘9. DIGITAL
DIALER SETUP’ is displayed and press .
Note: After completing the Digital Dialer Setup press
o to return to the top level programming menu.
PHONE NUMBER
Scroll through the menu until ‘9-1 Phone No:’ is
displayed. The current setting will also be display.
To change the setting press .
Enter the phone number (32 digits max. ranging from
0~9, *, #, ) that Central Monitoring station has.
Press to save and exit, or
Press to exit without saving.
Notes:
Press to insert a 3.6s pause in the dialing
sequence.
Press to move the cursor left.
Press to move the cursor right.
Press to delete the character under the
cursor.
Press and hold to erase the entire phone
number.
UNIT ID NUMBER
This helps central monitoring station set an ID number
for the user whose system is connected to their center.
Scroll through the menu until ‘9-2 Unit ID No:’ is
displayed. The current setting will also be displayed.
To change the setting press .
Enter the ID number (4 digits max. ranging from 0-9,
B,C,D,E, F)
Press to save and exit, or
Press to exit without saving.
Notes:
Press and then 1, a ‘B’ will be presented.
34
Press and then 2, a ‘C’ will be presented.
Press and then 3, a ‘D’ will be presented.
Press and then 4, an ‘E’ will be presented.
Press and then 5, a ‘F’ will be presented.
When pressing for 3 seconds, no further
input is made, it will be regarded as void input.
CALL ATTEMPTS
This sets the maximum number of times that the dialer
will attempt to contact the central monitoring station.
If the dialer contacts to the central monitoring station
once successfully, it will stop dialing.
Default setting: 3
Scroll through the menu until ‘9-3 Call Attempts’ is
displayed. The current setting will also be displayed.
To change the setting press .
Enter the required number (1-5).
Press to save and exit, or
Press to exit without saving.
OPEN/CLOSE BY USER
This determines when user makes a selection for
disarming (Open) or arming (Close) the system, an
event code 401 is needed to be sent to the central
monitoring station. When setting to ‘On’, an event
code 401 will be emitted, setting to ‘Off’, an event code
401 won’t be emitted.
Default setting: Off
Scroll through the menu until ‘9-4 Open/Close By
User’ is displayed. The current setting will also be
displayed.
To change the setting press .
Press to commence sending the event
code.
Press to commence not sending the event
code.