User's Manual

If the system is disarmed and the ‘ALARM MEM’ LED is
flashing with the panel beeping every few seconds, this
indicates that an alarm condition has occurred. Use
the Event Log to find out and make a note of where the
alarm occurred to assist in tracing the cause of the
alarm.
QUICK SET
To operate the quick set function and fully arm the
system in 5s, overriding the programmed exit delay.
Press
User Password
OMIT ZONE
To omit a zone from the next armed session:
Press
User Password
Scroll through the menu until the required zone is
displayed. The current setting will also be displayed.
To change the setting press .
Press to omit the zone, (i.e. zone omit ON).
Press to re-enable the zone, (i.e. zone omit
OFF).
After configuring zones to be omitted as required
Press to return to Standby mode.
Note: Omitting a zone will only affect the next armed
session. When the system is disarmed the omitted
zones will be re-enabled ready for the next armed
session.
PANIC ALARM
A full Alarm condition can be immediately initiated
at any time (whether the system is Armed or Disarmed)
in the event of threat or danger by activating a Panic
switch on either the Remote Control or the Control
Panel.
Remote Control:
Slide the Panic switch upwards.
Control Panel:
Press and hold the button for approximately
3 seconds.
The alarm will continue either for the alarm duration
when the system will automatically reset or until the
system is disarmed.
TAMPER
If the battery cover of any device is removed or if the
Siren or Control Panel are removed from the wall then
a Full Alarm condition will be initiated even if the
system is Disarmed. The alarm condition will continue
either for the alarm duration when the system will
automatically reset or until the system is Disarmed.
The ‘ALARM MEM’ LED on the Control Panel will flash
and the panel will beep every few seconds to indicate
an alarm has occurred.
Note: The Tamper protection facility on the Siren
operates independently. If the Tamper on the Siren is
activated this will not be indicated at the Control Panel.
CHIME
The Chime facility can only be operated with the
system in Standby mode.
Press to toggle the Chime facility between ON
and OFF.
Note: If the Chime is ON and the system is then armed
the Chime will remain ON after the system is disarmed.
EVENT-LOG
The Event Log will store the last 50 system Arm, disarm,
alarm and detector Low Battery events. The Event
Log will record the time, date and details for each event.
If when the system is disarmed the “ALARM MEM’ LED
is flashing and the panel beeps every 10s, this
indicates that an alarm has occurred. To cancel the
LED and stop the beeping you must access the event
log or press to eliminate the flashing ‘ALARM
MEM’ LED and the beeping as well.
To access the Event Log, (with the system in Standby):
Press .
The Event-Log will automatically start scrolling through
and displaying the event data starting with the most
recent event. The data for each event is shown on
two screens, each screen will be displayed for 5
37