User's Manual

6. Connect the power supply included

in the delivery to the central station

with reference to Fig. 2,

V+ cable with white lines

V- black cable.

7. If you also purchased an

emergency battery (12V / approx.

1.2Ah), connect this battery to the

plugs. Observe correct polarity! The

red plug connects to the positive

pole (+), and the black plug

connects to the negative pole (-).

8. The terminals POW and DIAL of

the central station can also be used

to connect the phone dialing

device S-126 for alarm transfer.

9. Use the jumper S1 to select the

alarm duration. This duration is

! 10 minutes with closed jumper

! 3 minutes with open jumper.

10. Now, connect the power supply to the mains supply.

11. A single "beep" tone signals that the central station is in standby mode, and the POWER LED

lights up.

12. Press the OFF key on the hand transmitter. Doing so, the central station automatically "learns"

your house code which will be confirmed by "beep beep".

Magnetic Contact Sensor HA 51M (Fig. 3)

13. The magnetic contact sensor is used to secure doors (Fig. 4), and

windows (Fig. 5). During mounting, make sure that the magnet is

attached to movable parts (window, door, etc.), whereas the sensor is

attached to fixed parts (border, frame, etc.).

14. Remove the cover of the sensor by sliding it

downwards (Fig. 6).

Fig. 2

Fig. 4 Fig. 5

Fig. 6