User's Manual

ManualsBrandsEverspring Industry ManualsElectronicsWireless PIR Alarm

864

UNIT:m

180°

TOP VIEW

1.5

SIDE VIEW

204

1.5

TOP VIEW

UNIT:m

90°

SP122 Wireless PIR Alarm

1 PIR Motion Sensor 6

2 Status LED 7

Low Battery LED 8

10 Siren

The Wireless PIR Alarm is designed to protect your

property, serving as a security system and entry

enunciator as well. Upon activation caused by

temperature fluctuation of human movement, a piercing

130 decibels alarm sound or chime alert will be emitted.

INSTALLING BATTERIES

The Wireless PIR Alarm requires 4 “AAA” batteries. If

the

LED of Alarm is flashing, the batteries need to

be replaced right away, otherwise the Alarm cannot be

working properly. Average battery life for typical usage

is 1 year.

To install the batteries:

1. Remove screw at base of compartment and slide

off cover. (FIGURE 1a & 1b)

2. Insert 4 “AAA” batteries ensuring correct polarity

being put. (FIGURE 2)

FIGURE 1a & 1b

FIGURE 2

Note: Remove batteries before storing the Alarm for

extended periods. Batteries corrode over time and

may cause permanent damage to the unit. Different

types of batteries or new and used batteries should not

be mixed. Depleted batteries should be removed from

the unit and disposed of properly.

CHOOSING A MOUNTING LOCATION

The Alarm is designed to be wall mounted. Since the

PIR can be swiveled 90° rightward & leftward, plan the

detection coverage according to the below options.

(FIGURE 3)

Option 1 Option 2 FIGURE 3

Option 1

Option 2

Note: We recommend that the Option 2 is applied to

the stairway detection where visitors or intruders may

pass through.

When considering and deciding upon the mounting

position for the Alarm, the following points should be

considered to ensure trouble free operation:

Summary of content (4 pages)

PAGE 1
Option 1 SP122 Wireless PIR Alarm TOP VIEW 8 6 4 2 180° 0 2 FIGURE 1a & 1b 4 6 8 1 PIR Motion Sensor 6 2 Status LED 7 3 8 Low Battery LED 4 9 5 10 Siren The Wireless PIR Alarm is designed to protect your property, serving as a security system and entry enunciator as well. Upon activation caused by temperature fluctuation of human movement, a piercing 130 decibels alarm sound or chime alert will be emitted. INSTALLING BATTERIES The Wireless PIR Alarm requires 4 “AAA” batteries.
PAGE 2
three times consecutively within 15 seconds, the Alarm will skip to off mode automatically. 1. Do not locate the Alarm facing a window or where it is exposed to or facing direct sunlight. The Alarms are not suitable for use in conservatories. 2. Do not locate the Alarm where it is exposed to ventilators. 3. Do not locate the Alarm directly above a heat source, (e.g. fire, radiator, boiler, etc). 4. Where possible, mount the Alarm on the flat wall at a 1.
PAGE 3
will send a “Stop” radio signal to the receiver. 2. Entry delay mode: Arm the Alarm by pressing your mode key. The 4-digit security code and then Alarm will have 15-second exit delay duration. The delay allows time for you to leave the protected area without triggering the Alarm. During this 15-second delay duration, the Alarm will bleep and Status LED will flash as a notification. The Alarm will enter delay mode after expiry of 15-second exit delay duration.
PAGE 4
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.