User's Manual
1
SR102 REMOTE TRANSMITTER
The Remote Transmitter is designed to control a series of O-net products, such
as EZ Alarm (SE131), On/Off Receiver (AN121, B410N) and Dimmer Receiver
(AD121, B410D), serving as a multipurpose remote controller. It is equipped with
7 sets of ID codes, therefore, each set of them is capable of controlling limitless
receivers.
LOADING THE BATTERY
1. Remove the battery cover. Fit the 3V Lithium battery in the compartment
provided with +v terminal facing upwardly. (Fig. 1)
Fig. 1
2. By pressing any key, the red LED will illuminate, which implies that the
battery has been inserted properly.
3. Replace the battery cover.
SETTING THE HOUSE CODE
The Transmitter incorporates 4 buttons and a 4-position house code slide switch.
The 4-position house code slide switch ranges from A to D. (Fig. 2) When
controlling EZ alarm (SE131), the house code slide switch has to be set in “A”
position, while “B”, “C” and “D” positions are designed for use with On/Off
Receiver (AN121, B410N), Dimmer Receiver (AD121, B410D), Lantern Receiver
(ED102) and forthcoming O-net series products.
4-position house code slide switch coupled with 4 buttons may formulate 7 sets of
ID codes, every of which is controllable to numerous receivers.
1. Setting the house code slide switch to “A” can operate EZ alarm (SE131).
House Code Position “A”
Button
No. of ID ID1 ID1 ID1 ID1
When switching to the “A” position which is situated in the orange background of
plate, simply follow its orange track for operating (instant arm), (delay
arm), (chime) and (disarm) modes.
2. Setting the house code slide switch to “B”, “C” or “D” position can take control
of On/Off Receiver (AN121, B410N), Dimmer Receiver (AD121, B410D) and
Lantern Receiver (ED102).
House Code Position “B” “C” “D”
1
st
. set of On, Off button ID2 ID4 ID6
2
nd
set of On, Off button ID3 ID5 ID7
4 buttons are divided into two sets, consisting of one pc each of On and Off
button. (Fig. 2)
Fig. 2 Fig. 3
Note: Write down each designated lighting fixture in each group by adopting the
sticker affixed on the rear cover. (Fig. 3)
1
st
. set
2
n
d
. set
House
code
slide
switch