Installation Guide

pieces of trim end-to-end, it is recommended that they each be trimmed at a 45 degree angle
to create a seamless appearance.
Step 2: Tongue and Groove Planking
Review instructions for installing the tongue and groove plank paneling located on its package
or on www.lowes.com.
Step 3: Chair Rail Trim
(sold separately from planks)
Cut the chair rail to measured length and apply adhesive to the back. Place the chair rail over
the planks so that the groove fits on top of them. Leave a 1/8 inch gap at the top of the
wainscot planks between the planks and the chair rail trim to allow for expansion and
contraction. Make sure that the chair rail is level before nailing into studs. If joining two pieces
of trim end-to-end, it is recommended that they each be trimmed at a 45 degree angle to
create a seamless appearance. Apply bead of caulk along the top, inner edge of the trim to fill in
any exposed gaps.