Installation Manual

A Note About Options

1. Internally installed photocell or surge protector are options for the 60W -

150W shoebox fixtures. Externally installed photocell, surge protector,

dimmer, or motion sensor are options for the 185W - 300W shoebox

fixtures.

2. For the dimmer option, do not remove the silicone protector cover for the

dimming wiring unless you are using the dimmer.

Warning

1. Minimum 75 degrees Celsius supply conductor.

2. All installations must be completed by a qualified, licensed electrician.

3. Must abide by any and all laws, regulations, and building codes in your

country, region, utility, or locality of any sort when installing the shoebox

fixture.

4. Do not use an electric generator to test the shoebox fixture.

5. Do not install or open the fixture in the rain. please wear electrical gloves

during installation.

6. Intended for outdoor installation.

7. During or after installation, if there is any smoke, sparks, or flame, shut

down power immediately. Contact relevant authority or customer service.

Wiring Diagram

1. Line or “hot” wire = Black/Brown.

2. Neutral wire = White/Blue.

3. Ground wire = Green/Yellow-green.

Optional Brackets

1. There are four optional brackets for this fixture. The following is a diagram

of the shoebox fixture with these brackets:

2. This fixture can also be used as an area or flood light, and with the wide

selection of brackets it makes it easy to mount virtually anywhere.

Installation Method 1: Adjustable (Slip-fitter) Mounting

1. To install the fixture with a pole mount, loosen the 4 locking bolts on the

slip fitter.

2. Connect the wires from the pole to the wires on the fixture.

3. Feed the wires into the pole and fasten the locking bolts between the slip

fitter and the pole (figure 1).

4. To adjust the fixture, loosen the fixing and adjusting bolts, then align the

fixture to the desired angle. Tighten the adjusting bolts and fixing bolts to

ensure the fixture is correctly fastened at the desired angle (figure 1).

PAGE 1
A Note About Options 1. Internally installed photocell or surge protector are options for the 60W 150W shoebox fixtures. Externally installed photocell, surge protector, dimmer, or motion sensor are options for the 185W - 300W shoebox fixtures. 2. For the dimmer option, do not remove the silicone protector cover for the dimming wiring unless you are using the dimmer. Optional Brackets 1. There are four optional brackets for this fixture.
PAGE 2
Installation Method 2: Yoke Mounting 1. To install the fixture with a yoke mount, loosen the fixing screw on the cap. Take the cap off. 2. Loosen the fixing bolt and affix the fixture to the support. Tighten the fixing bolts (figure 2). 3. Feed the AC wire to through the hole in the support and connect it. 4. Close the cap and tighten the fixing screw after placing the AC cable in the support (figure 2). 5.