User Manual

2-way SLI: Install your second GeForce

graphics card in the secondary PCIe x16 slot.

Connect the two cards together using a 2-way SLI bridge.

NVLink

technology is only supported by each GPU Speciﬁcation.

Install your ﬁrst GeForce

graphics card into the Primary PCIe x16 slot

(the Primary slot is the one closest to the CPU).

Attention: It is very important that you wait until the graphics card has cooled down before taking the card out of the system.

Remove the slot covers that correspond to the PCIe slots you are installing the GeForce

graphics card in

(if there was no existing graphics card).

Note : All of the graphics cards in an SLI

conﬁguration must be identical.

Install the GeForce

graphics card, as shown below. If this card is going into an SLI

conﬁguration, follow the

directions for the number of cards you will be installing.

Hardware Installation

PAGE 1
Hardware Installation 1. Attention: It is very important that you wait until the graphics card has cooled down before taking the card out of the system. 2. Remove the slot covers that correspond to the PCIe slots you are installing the GeForce® graphics card in (if there was no existing graphics card). 3. Install the GeForce® graphics card, as shown below. If this card is going into an SLI® conﬁguration, follow the directions for the number of cards you will be installing.
PAGE 2
4. Connect system power to the GeForce® graphics card. 2-Way 3 Slot SLI GeForce® graphics cards require PCIe power plugs from the system power supply. Ensure that all pins are populated by using the proper 6 or 8 pin PCle connector. 2-Way 4 Slot SLI 5. Reinstall the covers on your computer and reconnect any previously removed display cables.