User guide

ManualsBrandsEVGA ManualsComputer equipmentP67 FTW

EVGA P67 FTW Motherboard

Connecting Internal Headers

Front Panel Header

The front panel header on this motherboard is one connector used to connect

the following four cables.

(see Table 2 for pin definitions):

 PWRLED

Attach the front panel power LED

cable to these two pins of the

connector. The Power LED indicates

the system’s status. When the system is

powered on, the LED will be on.

When the system is turned off, the

LED is off. When the system is in S1, S3,

S4 status, the LED will blink.

Note: Some system cases do not have all four cables. Be sure to match the

name on the connectors to the corresponding pins.

 PWRSW

Attach the power button cable from

the case to these two pins. Pressing

the power button on the front panel

turns the system on and off rather

than using the onboard button.

 HD_LED

Attach the hard disk drive indicator

LED cable to these two pins. The

HDD indicator LED indicates the

activity status of the hard disks.

 RESET

Attach the Reset switch cable from

the front panel of the case to these

two pins. The system restarts when

the

RESET

switch is pressed.

Table 2.Front Panel Header Pins

Signal

HD_LED

1 HD_PWR

3 HD Active

PWRLED

2 PWR LED

4 STBY LED

RESET

5 Ground

7 RST BTN

PWRSW

6 PWR BTN

8 Ground

No Connect 9 +5V

Empty 10 Empty