User manual

PCoIP Multi-Monitor Deployment Guide
TER0905009 Issue 2 9
conflicts. If the deployment is to be used on its own network, then any four unique IP
addresses on the same subnet may be used.
This example uses the following example static IP addresses and MAC addresses:
• Host Card A: 192.168.1.200 (MAC: AA-AA-AA-AA-AA-AA)
• Host Card B: 192.168.1.201 (MAC: BB-BB-BB-BB-BB-BB)
• Portal A: 192.168.1.202
• Portal B: 192.168.1.203
The example in this document assumes you have a working knowledge using the PCoIP
Administrative Web Interface. For more information on use in the PCoIP Administrative
Web Interface, refer to the Administrative Web Interface User Manual (TER0606004).
Parameter Configuration
1. Determine the IP addresses given by the local DHCP router. (From the management
PC web browser browse to router configuration web pages, e.g. 192.168.1.1.)
2. On the management PC, browse to Portal A using the DHCP IP address determined
in Step 1.
3. Log in and select the Configuration->Initial Setup menu item. The Initial Setup
webpage for the Portal is shown in Figure 1-2
Figure 1-2: Portal Initial Setup
4. Configure Portal A using the Initial Setup webpage:
a. Step 1: If using audio, enable HD audio.