Manual

CS-14GMTR-MOD | Camera-Source | www.camera-source.com | support@camera-source.com

2014+ GM Truck Plug and Play Replacement Camera Installation Instructions

Thank you for your purchase! All information provided in this instructional guide is given on an as-is basis.

Professional installation is recommended!

BEFORE YOU BEGIN

READ AND UNDERSTAND THIS DOCUMENT BEFORE INSTALLING ANYTHING!

Compatibility: This kit is compatible with all 2014+ Silverado and Sierra trucks that had a camera from

the factory.

Wire Harness: The harness for this kit is designed to plug into the existing factory camera wiring.

KIT CONTENTS

 GM tailgate camera

 OEM conversion harness

REQUIRED TOOLS

 10mm socket or nut runner

 Torx

Section 1, Setting up

Unpack the contents of the package and gather the required tools listed above so you can be sure you

have everything you need before you begin. Read and understand these instructions thoroughly before

you begin the installation process.

Section 2, Camera Installation

1. Remove the trim panel from the back of the tailgate by using a Torx socket and removing the 8

screws holding it on to allow access to the camera.

2. Install the new camera module into your tailgate handle using the two Torx bolts that held the

original camera in. Route the camera harness through the bottom of your tailgate and bed.

3. Plug the camera into the OEM conversion harness pigtail. Note: This can only plug in one way!

Line up the arrows and the notch on the connectors and plug them together firmly.

4. Plug the other end of the camera pigtail into the factory harness (under the truck, behind the

rear bumper)

5. Secure the cable inside the tailgate using zip ties, ensuring that it is clear of moving parts.

6. Once the camera has been tested replace the tailgate access cover... SIMPLE!

PAGE 1
2014+ GM Truck Plug and Play Replacement Camera Installation Instructions Thank you for your purchase! All information provided in this instructional guide is given on an as-is basis. Professional installation is recommended! BEFORE YOU BEGIN READ AND UNDERSTAND THIS DOCUMENT BEFORE INSTALLING ANYTHING! Compatibility: This kit is compatible with all 2014+ Silverado and Sierra trucks that had a camera from the factory.
PAGE 2
PARKING GUIDELINES: Note that the camera has the parking guidelines enabled by default. To remove the camera guidelines simply snip the looped white wire that is protruding from the shrink tube on the camera wire near where the camera plugs into the chassis harness. Isolate each wire so they’re not touching. Note: You will want to remove the guidelines if you will be using the dynamic guidelines that have been built into the display from the factory.
PAGE 3
6 Month Limited Warranty This limited warranty applies to all Camera Source brand camera kits that contain the Super CMOS camera. Camera Source LLC warrants this camera is free from defects in materials or workmanship under normal use and service for a term of 36 months from the date of purchase.