User Guide

EVISTR VOICE RECORDER
http://blog.evistr.com [e-mail]
Page - 26 - of -28 -
Also, when voice activated function is ON, press REC, it will record 3 seconds, the device run 3
second to check the recorder was corrected entered recording mode. And then it will only pick up
loud enough decibels voice / sound.
11) Press REC, it not recording
First check, the recording light blink or not
Second, can you see VOR on the screen
If so, it means you have open the voice activated recording function, during this setting, it will only
records when high enough decibels sound detected, you could go to record setting, find AVR
sensitivity, and adjust it. It helps
But we suggest you could close the AVR mode, if you do not want this function
12) Press REC, Not Recording
When press REC, it doesn’t record, that means the voice recorder memory is full, or you have too
many “FOLDER” or “recordings” in the recorder.
Why this happened? Although you may not record too long time. Sometimes mistakenly RECORD,
and SAVE again and again, or copy or create too many “FOLDER” in the recorder disk. Maybe there is
some files that cannot be read by the recorder, so you cannot find directly from the recorder
So you need to format the voice recorder, or connect to computer and have a check, after that
format the recorder disk from your computer directly
13) Why it playback in random
Go to play setting, close the shuffle function
14) How to use the A-B repeat function
During playback, press and hold DEL, you will see A on the screen, and B is blink, it selected the start
point
Press and hold DEL again, select point B
Now it will playback between Point A to B
15) The recording is noise