Instructions / Assembly

OPERATOR INSTRUCTIONS
Affinity 30G
Evo, Inc., 20560 SW 115th Ave., Tualatin, OR 97062 USA
Phone [phone] | Fax [phone] | www.evoamerica.com | [e-mail]
32
REPLACING ELECTRONIC IGNITOR BATTERY
If the ignitor does not work, you may need to replace the battery.
1. Open left spillover tray door. Remove waste container.
2. Remove screw with #2 short handled phillips screwdriver.
(A)
3. Open battery cover by sliding cover back and pulling front out. Be careful of attached
ignition wires. (
B)
4. Pull the old 9V battery out and replace with a new one. Make sure to push it in all the way.
Place the cover back on. Replace screw for battery cover.
(C)
5. If the ignitor is still not working, contact Evo Customer Support for an ignitor replacement.
Remove screw with
#2 short handled
phillips screwdriver.
Remove the battery cover located on the
inside of the left drawer opening.
Replace screw for battery cover.
A
BC