User Manual

10
Drying operation mode
1. Press the MODE button in a sequence until the dry indicator is lighted.
2. The fan will run at a fixed speed at this operation mode.
3. Close windows and doors for the best dehumidifying effect.
Note: The setting temperature and fan speed can not be adjusted.The setting temperature
is 25° (77°F) and the fan speed is low.
Note: The setting temperature can not be adjusted.
Auto-restart function:
If power to the unit is interrupted, the unit will restart itself in its last used mode / settings
once power is restored. The compressor will restart after 4 minutes.
1. Set: Press the sleep button 10 times within 5 seconds, buzzer sounds 4 times.
2. Cancel: Press the sleep button 10 times within 5 seconds, buzzer sounds 2 times.
Circulation operation mode
• Press MODE button in sequence until the fan display is illuminated.
• Press the FAN button to select the fan speed.
• Press the ON/OFF button to start the unit and press it again to stop.
Removal of condensate water
When the internal water tank is full, the control panel display indicates “P1”.
• Open the drain cover and extract it upwards.
• Put a container under the drain pipe, take out the plug on the drain pipe and let out the
condensate water.
• After all the water has been emptied, replace the plug back onto
the drainage outlet, and replace the cover.
IMPORTANT This water is not suitable for drinking
Drain outlet