User Manual

20
3. «SPEED» button
Select fan speed as following:
LOW › MID › HIGH › AUTO
4. «DISPLAY»
• Press this button to turn on/off the display. This is for the convenience of users who
are uncomfortable sleeping with the backlight on.
5. «iFEEL»
• Press this button to set the temperature display on the remote controller to ambient
temperature and press this button again to set it to preset temperature.
6. «TIMER»
• With the unit ON, press this button to set OFF timer or with it OFF to set ON timer.
• Press this button once, a “ON (OFF)” will flash. Press “ ” or “ ” to set the number
of hours in which the unit will be turned ON/OFF, with an interval of 0.5 hour if less
than 10 hours, or 1 hour if longer than 10 hours , and a range of
0.5-24 hours.
• Press it again to confirm the setting, the “ON (OFF)” will stop flashing.
• If the timer button is not pressed longer than 10 seconds after the “ON (OFF)” start
flashing, the timer setting will be exited.
• If a timer setting is confirmed, pressing this button again will cancel it.
Note: When a ON timer is set, all function buttons (except SLEEP, DISPLAY and iFEEL
can’t be set) are valid and when the ON time set is up, the unit will operate as preset.
7. This button has two functions.
a. «HEALTH»
• Press this button with the unit ON to activate health related functions, such as the
removal of atmospheric particles, depending on the actual configuration of each model.
• Press this button again to deactivate the HEALTH function.
b. «iCLEAN»
Press this button with the unit OFF, the remote controller will display “CL” and the unit
will automatically clean dust off the evaporator and dry it, to increase the cooling and
heating efficiency.