User Manual

21
The iCLEAN function runs for approximately 30 minutes, during which if the unit is
turned on with the remote controller or this button is pressed again, the iCLEAN will be
deactivated.
8. “ ” or “ ”
Each time the “ ” is pressed, the temperature setting will increase by 1ºC and each
time the “ ” is pressed, it will decrease by 1ºC.
• The temperature setting ranges from 16ºC (60ºF) – 35ºC (90ºF).
Note: The temperature cannot be set in AUTO or FAN mode, thus these two buttons
are not functional.
9. «TURBO»
Press this button only in COOL or HEAT mode to set TURBO on or off to speedy the
cooling or heating.
• When TURBO is on, the air speed is HIGH.
• When TURBO is off, the air speed will restore to previous status.
10. «MODE» button
Enables you to select different operation modes after each press, the operation mode will
be changes. It shown in the following display:
AUTO
*
COO L
*
DRY
*
HE AT
*
FAN
*
AUTO.
Note: Cooling only units have no heating function.
11. «SLEEP»
• Press this button to enter SLEEP mode, which the unit will exit after 10 hours of
continuous operation and restore to the previous status.
Note: The SLEEP function cannot be activated in FAN mode.
12. «SWING »
Press this button to activate up/down swing and press it again to fix the swing position.
13. «SWING »
Press this button to activate left/right swing and press it again to fix the swing position.