User Manual

22
14. «Anti-F»
• The Anti-F functions when the unit is turned off with the remote controller in COOL,
DRY or AUTO mode. It will operate in HEAT mode (FAN mode for cool only units),
with the internal fan running with weak flow for 3 minute before stop, to remove
the moisture within the evaporator so as to prevent it from giving off bad smell from
mould.
• This function is not set in the factory. You may set it or cancel it any time you want
as follows: With both the unit and the remote controller OFF, point the remote
controller at the unit and press “Anti-F” button once, the buzzer will sound 5 times,
indicating this function is set. Once set, this function will remain valid except when
the unit is power off or until it is canceled.
To cancel Anti-F:
1. Power off the unit.
2. With both the unit and the remote controller OFF, point the remote controller at the
unit and press this button once, the buzzer will sound 3 times, indicating this
function is canceled.
Note:
• With Anti-F activated, it is advised not to turn ON the unit again before it is
fully OFF.
• Anti-F function will be invalid when OFF timer is set.
15. This button has two functions.
a. ELE.H
• If this button is pressed in HEAT mode, the electric heating will be turned on/off.
b. ECO
• If this button is pressed in COOL mode, the unit will enter the ECO mode which has
the lowest electricity consumption, and exit it automatically 8 hours after.
• Changing modes or turning off the remote controller will automatically cancel the
ECO function.
• Press ECO button in ECO mode to exit this mode.
Note: The ECO mode only works for inverter units.