User guide

³
Step 2 - Installing the new print head

Note the code shown on the white label stuck on the print head. You will be asked for this code in Step 3.

Pick up the new print head and turn it towards you, with the white connector visible.

Connect the cable into its socket, making sure it is the right way round. Do not use any force, as this part is relatively
fragile.

Turn the head so that the logo is visible (be careful), the connector can no longer be seen.

Insert the head vertically between the two guides so that the fork lugs are held within the slot.

The head is back in position.


4
39




 