Use and Care Manual

4
www.evolutionpowertools.com
If any of the symptoms become evident, seek
immediate medical advice.
• The measurement and assessment of
human exposure to hand-transmitted
vibration in the workplace is given in:
BS EN ISO 5349-1:2001 and
BS EN ISO 5349-2:2002
• Many factors can influence the actual
vibration level during operation e.g. the
work surfaces condition and orientation
and the type and condition of the machine
being used. Before each use, such factors
should be assessed, and where possible
appropriate working practices adopted.
Managing these factors can help reduce
the effects of vibration:
Handling
• Handle the machine with care, allowing the
machine to do the work.
• Avoid using excessive physical effort on
any of the machines controls.
• Consider your security and stability, and
the orientation of the machine during use.
Work Surface
• Consider the work surface material; its
condition, density, strength, rigidity and
orientation.
WARNING: The vibration emission during
actual use of the power tool can differ from
the declared total value depending on the
ways in which the tool is used. The need
to identify safety measures and to protect
the operator are based on an estimation
of exposure in the actual conditions of use
(taking account of all parts of the operating
cycle, such as the times the tool is switched
off, when it is running idle, in addition to
trigger time).
LABELS & SYMBOLS
WARNING: Do not operate this machine if
warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools
for replacement labels.
Note: All or some of the following symbols
may appear in the manual or on the product.
SYMBOL DESCRIPTION
V
Volts
A
Amperes
Hz
Hertz
Min
-1
Speed
~
Alternating Current
n
Rated Speed
Warning!
Read Instructions
Dry Cutting Only
Only applicable to R230DCT, R255DCT & R300DCT
models. Excludes R300DCT+.
Wear Safety Goggles
Wear Ear Protection
Wear Dust Protection
Wear Head protection
Wear Safety Gloves
Wear Safety Boots
Keep Hands away. Do not place your hand on or
below the line marked with this symbol on the
front handle. Ensure hand is kept above the line
& symbol at all times to ensure a safe distance
between your hand and the blade. Failure to do so
may cause injury. Applicable to R230DCT & R255DCT
US Certification
CE Certification
Regulatory Compliance Mark (RCM)
for electrical and electronic equipment.
Australian/New Zealand Standard.
GS Certification
Waste Electrical &
Electronic Equipment
Only use diamond blades,
do not use toothed blades
Don’t use defected or broken blades
High risk of kickback
Risk of dust inhalation
Risk of Fire. Ensure surrounding area is free from
flammable materials.
5015647