Use and Care Manual

Fig. 1.
Fig. 2.
Fig. 3.
2 33
Operating Instructions
Important
Please read these operating and safety instructions carefully and
completely. For your own safety, before using this equipment
check that the voltage is correct and that all handles and parts are
rmly secured. If you are uncertain about any aspect of using this
equipment contact your distributor.
Please Keep These Instructions
Model Evo380 Raptor Specications
Motor (230v or 115v 50/60 Hz) (Watts): 2200
RPM No Load (Speed 1) (min-1): 1450
Recommended Maximum Duty Cycle (Minutes): 30
Sound Power Level (Under Load) (dB(A)): 112.4
Vibration Level (No Load) (ms2) 1.39
Weight (Kg): 23
Max Dimensions (Raised) (mm): H 575 W 355 D 600
Maximum Box Cut Capacity 90
0
Square (mm): 120 x 120
Rectangle (mm): 95 x 180
Round (mm): 130
Wood (mm): 125 x 175
Maximum Box Cut Capacity 45
0
Square (mm): 89 x 89
Rectangle (mm): 78 x 110
Round (mm): 105
Wood (mm): 125 x 125
Blade Dimensions
Maximum Diameter (mm): 380
Bore Diameter (mm): 25.4
Thickness (mm): 2.4
Standard Equipment Supplied With Unit: 1 Jig Plate, 1 8mm Hex Wrench, 1
Safety Goggles, 1 Operating Instructions.
Ear and Eye protection MUST be worn whilst operating this
equipment. Do NOT touch the blade whilst it is in motion. Always
follow the Personal Protection Equipment (PPE) recommendations
whilst operating this tool.
This machine is designed specically for cutting steel & other materials
using the appropriate TCT (Tungsten Carbide Tipped) blades. It should
NOT be modied and / or used for any application other than for which it
was intended, including powering other equipment.
Ensure that the total work area can be viewed from the operating position.
Use barriers to keep people away. Do not operate the tool in explosive
environments – power tools create sparks that may ignite ammable
materials or gases. Do not operate the tool in damp or wet conditions or
areas, as electric shocks may result. Always use both hands to operate
the tool. Always ensure that the material you are working on is securely
clamped.
• This tool is equipped with an approved cord and plug for its intended
Country of use. The green and yellow conductor in the cord is the
earth / ground wire, never connect this to a live terminal.
• Remove plug from power supply before replacement of the blade,
making adjustments or other maintenance work.
• We recommend the use of genuine Evolution brand blades.
• Inspect the machine and blade before each use and do not use
deformed, cracked, worn or otherwise damaged blades.
• Ensure the blade is correctly mounted and do not stop by hand.
• Only use blades rated at 1500rpm or higher.
• Always keep the power cord away from moving parts of the tool.