Specifications

21Hangar 9 Sukhoi SU-26MM SE
Note: Always use threadlock on metal-to-metal fasteners.
 2. Attach the rudder servo arm onto the rudder servo
using a 2.5mm hex wrench. Once installed, tighten
the clamping bolts using a 3/32 hex wrench.
 3. Apply 2–3 drop of thin CA in each of the holes for the
tail wheel bracket mounting screws.
 4. Check the fit of the tail wheel assembly on the bottom
of the fuselage to make sure the rudder hinge wire
does not interfere or make contact with the top of
the tail wheel carbon leg during its installation. If the
rudder hinge wire does interfere, use a drill as shown
in step 1 to insert the wire slightly into the rudder
balance tab or use side cutters to trim the excess
wire. Attach the tail wheel assembly to the fuselage
using two 2.5mm x 18mm socket head sheet metal
screws. Use a 3mm hex wrench to tighten the
screws.
Note: The tail wheel assembly will keep the rudder hinge
wire from vibrating loose from the rudder hinges.
 5. Connect the steering arm from the rudder to the steering
arm on the tail wheel using two steering springs.
Stabilizer Installation
Required Parts
Fuselage assembly Stabilizer/elevator (2)
Stabilizer tube #4 nylon washer (4)
Required Tools and Adhesives
Threadlock Hobby knife
Hex wrench: 5/64-inch Canopy glue
 1. Slide the stabilizer tube into one of the stabilizer
halves.
 2. Remove the two 4-40 x 1/2 inch button head screw
and #4 nylon washers from the fuselage using a
5/64-inch hex wrench. Connect the lead from the
stabilizer to the lead in the fuselage. Secure the
extension using the supplied connector so it will not
unplug.