Specifications

22 Hangar 9 Sukhoi SU-26MM SE
 3. Use the screws removed from the fuselage in Step
2 to secure the stabilizer to the fuselage.
Note: A small of canopy glue on the threads of the
stabilizer mounting screws will allow for easy removal, but
help prevent the screws from vibrating loose in flight.
 4. Repeat Steps 2 through 3 for the remaining stabilizer.
Landing Gear Installation
Required Parts
Fuselage assembly Landing gear assembly
Wheel pant (right and left) 6-32 lock nut (4)
#8 washer (4) #4 washer (4)
Wheel and axle assembly (2)
4-40 x 1/2-inch socket head screw (4)
8-32 x 3/4-inch socket head screw (4)
Required Tools and Adhesives
Threadlock Light machine oil
Open end wrench: 10mm, 13mm
1/4-inch ratchet drive
11/32-inch socket, 1/4-inch drive
3-inch (76mm) drive extension, 1/4-inch drive
Hex wrench: 3/32-inch, 1/8-inch
 1. Use a 3/32-inch hex wrench to remove the 4-40 x
3/4-inch socket head screws securing the landing
gear cover from the fuselage.
 2. Remove the lock nut from the axle. Insert the axle
in the large hole of the landing gear. Use a 10mm
and 13mm open end wrench to tighten the lock nut,
securing the axle to the landing gear. Install both
wheels at this time.
 2. Attach the landing gear to the fuselage using four
8-32 x 3/4-inch socket head screws, four #8 washers
and four 8-32 lock nuts. Use a 11/32-inch socket
wrench with extension and driver and 1/8-inch hex
wrench. Note the gear will angle forward slightly
when installed.