Instruction manual

10
www.evolutionsteel.com
GETTING STARTED
WARNING: Always disconnect the saw from the
power source before making adjustments.
Refer to the “Service Parts Diagram”. Install a blade
as detailed in the “Installing or Removing a Blade”
section.
WARNING: Never start the saw with the cutting
edge of the saw blade in contact with the workpiece
surface. Do not retract blade guard manually. Guard
retracts automatically.
This saw is equipped with an approved cord and
plug for its intended Country of use. Do not alter or
modify the power cord.
Installing or Removing a Blade
WARNING: Only use genuine Evolution blades
which are designed for this machine. Ensure that
the maximum speed of the blade is compatible with
the machine. Only perform this operation with the
machine disconnected from the power supply.
Note: It is recommended that the operator
considers wearing protective gloves when handling
the blade during installation or when changing the
machines blade.
1. Place saw on a level, secure surface.
2. Remove the chip collector from the machine by
undoing the (2) large thumb screws. (Fig. 1)
Note: The chip collector thumb screws are ‘captive’
and cannot be removed from the machine.
3. Lock the machine arbor by engaging the arbor
lock. (Fig. 2)
4. Using the supplied Allen Key loosen and remove
the arbor socket headed screw and outer blade
drive ange. (Fig. 3)
5. Remove the saw blade.
6. Thoroughly clean inner and outer blade drive
anges and blade mounting surface before
installing a new blade.
7. Ensure that the direction of rotation arrows
printed on the blade, match the direction of rotation
arrow found on the chip collection cover. (Fig. 4)
8. Reinstall the outer drive ange and the arbor
socket headed screw.
9. Engage the arbor lock and tighten the arbor
socket headed screw securely using the Allen key.
Note : The socket headed arbor screw has a RH
thread.
GETTING STARTED
GB
FIG 1
FIG 2
FIG 3