Instruction manual

www.evolutionfury.com
14
GETTING STARTED
WARNING: ALWAYS DISCONNECT
THE SAW FROM THE POWER SOURCE
BEFORE MAKING ANY ADJUSTMENTS.
Refer to the “Service Parts Diagram”. Install
a blade as detailed in the “Installing or
Removing the Blade” section.
NOTE: We recommend that the operator
reads the ‘Important Information’ sticker
applied to the table of the Fury6. Practicing
and becoming familiar with the procedures
outlined on this sticker will make subsequent
adjustments/assembly or configuring fairly
straightforward.
PERMANENTLY MOUNTING THE FURY6
TABLE/MITRE SAW (Fig. 1)
WARNING: To reduce the risk of injury from
unexpected saw movement, place the saw
in the desired location either on a workbench
or other recommended leg set. The base of
the saw has four holes to mount the mitre
saw. If the saw is to be used in one location,
permanently fasten it to the workbench or
leg set using appropriate bolts with lock
washers and nuts.
NOTE: When permanently mounting the
Fury6 we recommend that the four (4)
rubber feet located underneath each of the
mounting holes are removed and stored
safely for possible future use.
1. Tighten the mitre and bevel locks.
2. Position the saw so other people cannot
stand behind it. Thrown debris could injure
people in its path.
3. Place the saw on a firm, level surface
where there is plenty of room for handling
and properly supporting the workpiece.
4. Support the saw so that the table is level
and the saw does not rock.
5. Bolt or clamp the saw to its support.
For Portable Use (Fig. 2)
NOTE: The Fury6 is designed to be a highly
portable machine.
For portable use the Fury6 must be fitted
with the two (2) rear Stabilising Arms.
To fit the Stabilising Arms:
• Remove the cross head machine
screws from the two (2) rear mounting
positions.
• Attach the Stabilising Arms with the
machine screws, two per arm and
tighten securely.
NOTE: The Stabilising Arms are fitted with
rubber feet. The base of the Fury6 is also fitted
with four (4) identical rubber feet positioned
underneath the mounting holes in the base.
When used as a portable machine the six (6)
rubber feet provide the security and stability
necessary for safe operation.
1) Hex headed bolt M8 X 75
2) Spring washer
3) Flat washer
4) Mitre saw base
5) Workbench
6) Flat washer
7) Spring washer
8) Hex nut
9) Lock nut
Fig. 1
9
5
6
7
8
3
4
2
1
THESE ITEMS
ARE NOT
SUPPLIED
M8 x 75