Instruction manual

www.evolutionfury.com
21
TO CONFIGURE THE FURY6 FOR USE AS
A TABLE SAW
WARNING: Do not cut metal or metallic
materials when the machine is configured
as a Table Saw.
WARNING: Only carry out this procedure
with the machine disconnected from the
power supply.
Caution: The Fury6 has many built in safety
features and safety interlocks. It is important
that the following instructions, and those
found on the label attached to the machine
table are read, understood and acted
upon. Failure to carry out the configuration
procedure could result in damage to the
machine and/or injury to the operator.
• EnsurethattheRotaryTableissetat0
0
Mitre angle and the Cutting Head is set at
0
0
Bevel angle.
• PositiontheAuxiliaryLowerBladeGuard
on the Rotary Table over the table insert
and straddling the Fence. (Fig. 16)
• LowertheCuttingHeadtothefullydown
position, ‘capturing’ the Lower Auxiliary
Blade Guard. Push the Cutting Head
Latching Pin into its socket. (Fig. 17)
• LoosentheTableHeightAdjustment
Screw (Fig.18) and lower the table to its
lowest position.
• TightentheHeightAdjustmentScrew.
The Fury6 is now ready to use as a
Table Saw.
Fig. 18
Fig. 17
Fig. 16