Instruction manual

www.evolutionfury.com
7
ADDITIONAL SAFETY INSTRUCTIONS
FOR YOUR TABLE MITRE SAW
WARNING: Be sure to read and
understand all instructions. Failure to
follow all instructions listed below may
result in electric shock, fire and/or serious
personal injury.
1. Know your power tool. Read operator’s
manual carefully. Learn the applications and
limitations, as well as the specific potential
hazards related to this tool.
2. Always wear safety glasses or eye
shields when using this mitre saw.
Everyday eyeglasses have only impact-
resistant lenses; they are not safety glasses.
3. Always protect your lungs. Wear a face
mask or dust mask if the operation is dusty.
4. Always protect your hearing. Wear
hearing protection during extended periods
of operation.
5. Inspect the machines power cord regularly
and if damaged have it repaired or replaced.
Always be aware of the cords location.
6. Always check for damaged parts.
Before further use of the tool, a guard
or other part that is damaged should be
carefully checked to determine if it will
operate properly and perform its intended
function. Check for misalignment or binding
of moving parts, breakage of parts, and
any other condition that may affect the
tool’s operation. A guard or other part that
is damaged should be properly repaired or
replaced at a qualified service centre. Keep
guards in place and in working order.
7. Do not abuse the cord. Never use the
cord to carry the tool or pull the plug
from the outlet. Keep cord away from
heat, oil, sharp edges or moving parts.
Replace damaged cords immediately.
Damaged cords increase the risk of electric
shock.
8. Always make sure that your extension
cord is in good condition. When using an
extension cord be sure to use one that is
heavy enough to carry the current that your
tool will draw. An undersized cord will cause
a drop in line voltage, resulting in loss of
power and overheating.
9. Do not use the tool while tired or under
the influence of drugs, alcohol or any
medication. Following this rule will reduce
the risk of electric shock, fire or serious
personal injury.
10. Save these instructions. Refer to
them frequently and use them to instruct
others who may use this tool. If someone
borrows this tool, make sure they have
these instructions also.
11. When the correct blade to cut the
material has been fitted, this saw is
recommended for cutting steel and
ferrous metals, aluminium and non-
ferrous metals, wood, and plastic only.
12. Do not use saw blades with High
Speed Steel (HSS) or blades that are
damaged or deformed.
13. Replace the table insert when worn.
14. Use only saw blades recommended
by the manufacturer and which are the
exact bore and diameter required for this
machine.
15. Connect your mitre saw to a dust
collecting device (O.D.Ø32mm) when
sawing material likely to cause dust.
16. Select saw blades in relation to the
material to be cut. Use only genuine
Evolution or Evolution recommended
accessories.
17. Check the maximum depth of cut.
18. When sawing long work pieces,
always use extra support to provide
better support, and use clamps or other
clamping devices.
19. Make sure the operator is adequately
trained in the use, adjustment and
operation of the machine.
20. Provide for adequate room lighting at
your workplace or for adequate lighting
of the immediate work area.
21. Refrain from removing any cut-offs
or other parts of the workpiece from
the cutting area whilst the machine is
running and the saw head is not in the
rest position. Never reach around the saw
blade. Turn off tool and wait for saw blade to
stop before moving workpiece or changing
settings.