Instruction manual

30
www.evolutionpowertools.com
NOTE: Approximately 75mm of the
Workpiece Support Bar should slide into the base to
provide positive location.
• Tighten the retaining screw.
• Repeat the above for the Left Hand side.
To remove a Workpiece Support Bar, simply loosen the
relevant retaining screw and slide the Workpiece Support
Bar from the machine. Store safely for future use.
THE REPEAT STOP (Fig. 42)
The use of the Repeat Stop can greatly aid the operator
when conducting repetitive cutting operations. When
many pieces of material all cut to the same length are
required, use of the Repeat Stop can assist accuracy
and efficiency.
Fitting the Repeat Stop
• Loosen the Repeat Stop thumb screws sufficiently
to allow the arms of the Workpiece Support Bar to
slide through the holes in the Repeat Stop.
• Position the Repeat Stop approximately half way
along the Workpiece Support Bar, and tighten the
thumb screws to minimize any movement.
• Attach the Workpiece Support Bar to the machine
base as previously detailed.
NOTE: By loosening the thumb screws the Repeat
Stop can be adjusted to the required distance from the
saw blade for repetitive cutting operations etc. The
Repeat Stop can be fitted to either of the Workpiece
Support Bars but normally will be positioned to the
Right Hand side of the blade.
Fig.42
Repeat Stop in position