Operating instructions

24
www.evolutionpowertools.com
45
0
Bevel Stop Adjustment
• Loosen the Bevel Lock Handle and tilt the Cutting Head
completely to the left until it rests against the 45
0
stop.
• Use a Set Square to see if the blade is at 45
0
to the table
(avoiding the TCT tips).
• If the saw blade is not in exact alignment adjustment is necessary.
• Return the Cutting Head to its upright position.
• Loosen the locknut on the 45
0
Bevel Adjustment Screw.
• Use a Hex Key to adjust the Adjustment Screw in or out as
required. (Fig. 16)
• Tilt the Cutting Head to the 45
0
setting and recheck for
alignment with the Set Square.
• Repeat the above steps until the correct angular alignment
is achieved.
• Tighten the Adjustment Screw locknut securely once
alignment is achieved.
CROWN MOULDING
The Cutting Head can be tilted (to the LH side only) and locked
at an Bevel angle of 33.9
o
. The rotary table can be set at 31.6
o
Mitre angle to the left or right hand side. This allows the Rage
machine to be used for cutting 38
o
Crown Moulding.
To check the 33.9
o
angle the operator will require a vernier
angle gauge (not supplied).
To check the 33.9
o
Bevel Angle stop:
• DeploytheCrownMouldingPin(seeOperations)
• LoosentheBevelLockingHandleandtilttheCuttingHeadto
the 33.9
o
position.
• Slidethevernieranglegaugeintopositionwithonearmresting
on the rotary table and the other resting on the tilted blade.
• Readofftheanglesetting.
If adjustment is required:
• Loosenthelocknutonthe33.9
o
Adjustment Screw.
• UseaHexKeytoadjusttheAdjustmentScrewinoroutas
required. (Fig. 17)
• Whencorrectadjustmentisachieved,locktheAdjusting
Screw by tightening the locknut.
FENCE ALIGNMENT
The fence must be aligned at 90
0
(square) to a correctly installed
blade The rotary table must be set at ‘0
0
’ miter angle.
The Fence is fastened to the table with two socket head Hex screws
positioned at either side of the fence in elongated slots. (Fig. 18)
Fig. 17
Fig. 16
Fig. 18