Use and Care Manual

3.4 Install Sills (Optional)

Beginning at the corners, make cuts or miter as necessary. Fasten the sill pieces through the vertical

face using two exterior grade concrete screws centered 4” from each end. Predrill at the fastener

locations as necessary per the manufacturer’s recommendations and provide a recess so the

screw head sits slightly below the face of the stone.

ro-Tip: Using a color matched exterior grade polyurethane sealant ﬁll any screw countersink holes or

ﬁll the gaps bridging two abutting sills.

3.5 Install Outside Corners (Optional)

Start at the bottom of your corner assembly and work your way up. Fasten each leg of the corners

with TremcoTM TREMGrip adhesive. Treat each leg as its own stone and follow the appropriate

adhesive guidelines as speciﬁed in section “2.5 Adhesive Guidelines” above.

Pro-Tip: Install your outside corners according to a comfortable lift height for the installer.

Generally, this means 2’ to 3’ linear feet at a time and then install your ﬁeld stones before beginning

the next lift of your corners.

Pro-Tip: Alternate corner leg orientations of your outside corners as best as possible to avoid creating

matching vertical seams.

3.3.6 Installing the Stones

Follow the same instructions as outlined in “2.4 Installing the Stones” in the Standard

Install Method above.

3.3.7 Cutting Evolve Stones

Follow the same instructions as outlined in “2.5 Cutting Evolve Stones” in the Standard

Install Method above.

EVOLVESTONE.COM