User Manual

ManualsBrandsEvolve ManualsDimmersLRM-1000

Evolve LRM-1000, Series 300, Rel. 5.2 Instructions

P/D 0915111

LRM-1000

by Evolve Guest Controls

Evolve Radio Frequency (RF) Controlled, 1000W, 120 VAC,

NWI and Scene Capable, Wall Mounted Dimmer, Series 300, Release 5.2

LRM-1000

LRM-1000 WALL MOUNTED DIMMER

The LRM-1000 Wall Mounted Dimmer is a component of the Evolve Guest Controls lighting control system. Wire

the Wall Mounted Dimmer in place of the standard wall switch according to the diagram above and program from

the Wireless Controller to operate loads. Inclusion of the LRM-1000 Wall Mounted Dimmer on the EHC-100

Wireless Controller menu allows remote ON/OFF control and dimming of lights connected.

This Wall Mounted Dimmer is designed to work with other EvolveNet enabled devices. EvolveNet nodes of other

types can be added to the system and will also act as repeaters to increase the range of the network

This product is scene capable.

This product supports 40Kbps data transmission. This product can also be used for networking support in systems

that stream metadata. An example might include transmission of information from audio devices such as song

title, artist, and album information to various displays.

DANGER! SHOCK HAZARD. Read and understand these instructions before installing. This device is intended

for installation in accordance with the National Electric code and local regulations in the United States, or the

Canadian Electrical Code and local regulations in Canada. It is recommended that a qualified electrician perform

this installation. There are no field repairable assemblies on this unit. If service is needed, the unit must be returned

where purchased.

CAUTION! To reduce the risk of overheating and possible damage to other equipment, do not install

to control a receptacle, a motor operated appliance, a fluorescent lighting fixture, or a transformer-supplied

appliance, but only permanently installed incandescent lamp fixtures. Make sure the lamp(s) to be controlled

directly from this dimmer total no more than 1000 watts. Do not install this device if there is not at least 10 meters

(30 feet) or more of wire between the point of connection and the electrical service panel. Retain instructions for

future use.

Standard color: White

Supplied with matching

decorative switch plate.

Other replaceable trim

kits available.

Note: This module must be “Included in the Network”

only where it will be permanently installed. The proper

operation of this node in the mesh network is dependent

on it knowing its location with respect to other nodes. You

cannot “test bench” configure this module.

• This product supports Zensor Net Beam technology

• NWI and Scene Capable

Summary of content (4 pages)

PAGE 1
LRM-1000 Evolve Radio Frequency (RF) Controlled, 1000W, 120 VAC, NWI and Scene Capable, Wall Mounted Dimmer, Series 300, Release 5.2 Standard color: White Supplied with matching decorative switch plate. Other replaceable trim kits available. Note: This module must be “Included in the Network” only where it will be permanently installed. The proper operation of this node in the mesh network is dependent on it knowing its location with respect to other nodes. You cannot “test bench” configure this module.
PAGE 2
INSTALLATION STEP 1.. With POWER OFF, wire this LRM-1000 according to the diagram shown. Caution! Do not wire unit “live” (with power on the circuit). Apply power when completed. Proper Single Gang Installation Using LRM-1000’s standard full heat-sink (all tabs), the connected incandescent lamp load shall not exceed 1000W. If a tab is removed from one side of the LRM-1000 unit, the connected incandescent lamp load must not exceed 900W.
PAGE 3
LED indication The LED on the LRM-1000 will turn ON when the load attached is OFF to act as a night light. However, the LED can be user configured to turn ON when the load attached is ON, if so desired, Remote Control The LRM-1000 will respond to BASIC and MULTILEVEL commands that are part of the EvolveNet system. Refer to your controller’s instructions as to whether your controller can transmit those commands. All On/All Off The LRM-1000 supports the ALL ON/ ALL OFF commands.
PAGE 4
SPECIFICATIONS Power 120 VAC, 60 Hz. Maximum Load 1000W, incandescent lamps only. Signal (Frequency) 908.42 MHz. Range Up to 100 feet line of sight between the Wireless Controller and /or the closest HomePro Receiver Module. INTER-OPERABILITY WITH EVOLVE™ DEVICES An Evolve™ network can integrate devices of various classes, and these devices can be made by different manufacturers. The LRM-1000 can be incorporated into existing Evolve™ networks.