NETUM Barcode Scanner Manual ·Bluetooth Connection ·2.4GHz Connetion . USB Wired Connection Package Included: 1 X Scanner; 1 X 2.
Quick Setup Guide. How to Start ? There are three kinds of connections modes: USB Wired 2.4GHz Wireless Connection Bluetooth Connection Follow one of the following connection modes to get started. Working via USB Cable ①.Connect scanner with your device via USB cable. ②USB HID-KWB mode is set by default, if you want to work under virtual serial port please refer to" USB COM (Virtual Serial Port)". (Page) ③. Set Keyboard language→See page () . US keyboard was set by default. ④.
%#IFSNO$4 Bluetooth Transmission Bluetooth Connection Modes There are three kinds of bluetooth connections modes: ① Basic Mode (HID) (Default)* Human Interface Device Profile By scanning below barcode scanner will enter "Basic Mode".
If you have an iOS application that supports our scanners this is the mode you want to use Important Note: 1. Scanner will power off automatically if device is not connected within 1min. 2. If you want to shift from HID to SPP or BLE just scan the Corresponding command barcode. If you want to shift from SPP or BLE to HID mode, first ignore (or delete) "Netum Bluetooth"→ turn off bluetooth→ scan command barcode of HID→ Open the bluetooth → repair it.
Apple: Connect Apple iOS Device (HID) 1.Power on the scanner. Blue LED light will start to flash. 2. Start a Bluetooth device search. IOS: Tap Settings | General| Bluetooth. Turn on. A Bluetooth device search will begin. 3. In the device list, tap on “Netum Bluetooth”. Tap Pair. 4. The scanner will make one beep once it’s connected and LED light will turn to solid blue and is ready to scan. Windows: Connect Windows PC(HID) 1.Power on the scanner. Make sure the scanner is discoverable (unpaired). 2.
Germany keyboard Italy keyboard Spain keyboard Turkey Q keyboard UK keyboard Canadian FR keyboard Working Mode (Apply for 2.4GHz and Bluetooth Connection) If you are heading for a working area which lies outside the Bluetooth signal range, you may activate scanner’s store mode, following steps described below. Under this mode, all scanned data will be stored directly into the buffer memory of the device.
Beep OFF Beep On: Enable scanner to beep to indicate successful scans. *Beep On Terminator The scanner provides a shortcut for setting the terminating character suffix to CR or CRLF and enabling it by scanning the appropriate barcode below. CR+LF TAB No terminator Idle Time Scanner connected to a device will power off within 1 min if idle/inactive. By scanning below command barcode will change the idle time.
*1 Min 3Mins 10Mins 30Mins Charge the battery When scanner make 2 beeps or battery volume under 20% please plug the cable into scanner and connect the other side with your device to charge power for it. By scanning below barcode you can get the remaining battery volume. Get Battery Rough Volume Red Light = Charging Green Light= Fully charged Firmware Version: Read below command barcode to check scanner’s firmware version.
2 beeps Prompt Tone 1 long beep 1 short beep Warning Tone 2 beeps 3 beeps Continuous beeps ①Successful scan on command barcode; ②Power On ③USB cable connected ①Bluetooth connected, ①successful scan on normal barcode; ②Power Off ①Low battery volume ①Data transmit failed; ②Memory is full ①RF pairing LED Indication RED GREEN BLUE ON THEN OFF BLUE LIGHT KEEPS BLINKING SOLID BLUE,NO BLINKING RED ON= Charging GREEN ON= Fully Charged Successful scan Bluetooth Pairing/RF Pairing Bluetooth Connected FCC War
