Owner's manual

Steam Dynamo
Cleaning Floors
6
Instructions for Use
• Make sure the machine is unplugged from
the electrical outlet.
• Unscrew the Safety Cap (2) by turning
anti-clockwise.
Please note the cap cannot be unscrewed
when the unit is pressurized.
• Using the measuring Jug (6) and Funnel
(6a) fill the machine with 50 fl.oz (1500ml)
of water. This should be sufficient to steam
clean for approximately 45 minutes.
• Once full, replace the Safety Cap (2) by
turning clockwise and fasten tightly.
• Attach the accessory or floor cleaning tool
you require to the machine (see page 4).
• Now plug the machine into the electrical
outlet and switch on. Two lights should
illuminate. The RED light is a power
indicator. The ORANGE light indicates
that the machine is building steam
pressure. When the machine is first turned
on this light will illuminate. The machine
takes up to 12 minutes to reach the correct
pressure level depending on the amount of
water in the tank.
• Once the ORANGE light has gone out the
machine is ready to use. The ORANGE
light may come back on when the machine
is in use. If this happens, release the safety
trigger at the Steam Gun (3) and allow the
steam pressure to build up again. This
should take no longer than 40 seconds. If
the safety trigger is pressed when the
ORANGE light is on, hot water may come
out of the machine.
Refilling the water tank
• Switch the machine off using the ON/OFF
button.
• Disconnect the power cable from the
electrical outlet. Wait 5 minutes before
squeezing the trigger to make sure the
machine is no longer under pressure
before unscrewing the Safety Cap (2). DO
NOT unscrew the safety cap until the
steam has stopped.
• Fill the water tank as necessary using the
Funnel (6a) provided. DO NOT exceed
50 fl.oz (1500ml) of water. Replace the
Safety Cap (2) by turning clockwise.
Fasten cap tightly.
• You are now ready to switch the machine
on and resume steam cleaning.
EB0029 Steam Dynamo 0114.qxp_Layout 1 16/01/2014 14:08 Page 6