User's Manual

Ewig Industries Co Ltd Smoker thermometer

Prepared By: Tony Wu Dated: March 26, 2003

This screen automatically toggles to displays the temperatures of the both probe

sensors periodically (readings of probe only in °F).

METAL HOOK for hanging, or reversed to use as a stand

BATTERY COMPARTMENT:

Holds 2 AAA batteries

PLUG IN JACK for stainless steel FOOD probe sensor

PLUG IN JACK for stainless steel SMOKER probe sensor

Functions of Buttons on the Transmitter:

1. TX:

Before first use, press and hold to register radio frequency with Receiver (see

“Getting Started” below).

2. ON/OFF:

Turn the transmitter unit on or off.

Installing Batteries

Make sure both receiver and transmitter units have the ON/OFF switch set to OFF.

Open the battery compartments on the receiver and transmitter. Insert two AAA

batteries into each compartment.

Getting Started

Before first use, you’ll need to set the receiver to register the radio frequency signal

from the transmitter. This is called the “registration procedure”.

1. Plug the stainless steel probe sensors into the plug-in jacks on the transmitter

matching the FOOD and SMOKER markings.

2. Using the ON/OFF switches, first turn on the receiver (ON/OFF switch at back)

(display shows “- - - “ blinking). Then turn on the transmitter (ON/OFF switch

inside battery compartment – which can be open using a coin).

3. The registration procedure is complete when the receiver beeps and the LCD

displays the current temperatures for both smoker and food (provided both probes

are inserted)

If the registration procedure fails, the readings will show “- - - “ steady. Use ON/OFF

switch to reset the receiver, and press the TX button (located on the rear of the

transmitter) and hold for 2 seconds. This needs to be done within 60 seconds of

turning the receiver on in order for the receiver to register the signal from the

transmitter. Once TX is released. It will take several seconds for the receiver to

Cooking According to Settings

Our remote thermometer features programmable cooking temperature settings for

foods safety. The temperatures displayed to the left of the LCD screen will show the

set temperatures.

To show and set maximum and minimum smoker temperature

1. Hold Light/MODE button to select smoker mode. The lower display will show a

small SMOKER icon and temperature reading