Technical Manual

East Wind Technologies, Inc.
Copyright © 2022 East Wind Technologies, Inc. All rights reserved. 31/59
3.6 MIFARE Plus Card Commands
EWTJ680H-I reader module support MIFARE Plus card operation. NXP MIFARE Plus
cards are used to instead MIFARE 1 card. We provide application commands are based on Level
3. In the card level 3, the authentication use AES encryption algorithm. In the communication
process between module and card, all are using encrypted data + command with MAC + response
with MAC mode. So the security of RF communication is extremely high.
Use the following command allows the user to quickly start MIFARE Plus R & D works.
But for advanced user, also could use APDU to implement the card.
3.6.1 MIFARE Plus Prepare Commands
3.6.1.1 MIFARE Plus Request
For MIFARE Plus card request, please refer to ISO14443 TYPE A Request.
3.6.1.2 MIFARE Plus RATS
Please refer to ISO14443-4 TYPE-A card reset (RATS).
3.6.1.3 MIFARE Plus Request and RATS
Please refer to Card Request according to EMV and PBOC.
3.6.2 MIFARE Plus Initialization Commands
3.6.2.1 MIFARE Plus Write Perso
Function: Initialization of the AES key and all other blocks. About these blocks address and
the default value please reference the MIFARE Plus datasheet or contact us.
Host sends:
Frame
0x33
Address
Data
Checksum
Address: 2 bytes block address, MSB first.
Data: 16 bytes.
Success:
Frame
0x33
Status
Checksum
Status: status code returned from the card, the communication between the card and
module is successful, but may not meet the conditions for the implementation.
Please reference: MIFARE Plus Returned Status Code.
Failure:
Frame
0xCC
Checksum
3.6.2.2 MIFARE Plus Commit Perso
Function: Level 0 command, to switch Level0 to Level1 or Level3. Target Level depends on