EXAKT PS-160 Instructions for Use Distributed by JML USA, Inc. 3PL Worldwide 500 Bic Drive Ground Floor, Building 4 Milford, CT 06461.
PS 160 Safety Warnings Instructions for Putting Into Use Setting up the Saw for Use After unpacking check that there are no parts missing or damaged. If there are contact supplier and do not operate. PS 160 Safety Warnings – Operating Instructions This tool should always be used with the dust hose connected and attached to a suitable vacuum cleaner/dust extractor. Setting the Cutting Depth Before using a blade needs to be fitted as described in the operating instructions.
cover, insert the torx key into the blade retaining screw and unscrew clockwise. (Diagram C) b) Depress the guard to remove the blade. c) Place the new blade onto the blade shaft ensuring the hole locates correctly and the teeth point forwards in the direction of the curved arrow. (Diagram C) d) Replace the safety retaining washer and tighten the screw. (Diagram D) e) Remove both keys before plugging in. Guard Removal NOTE: Do not use without the Guard.
F Then plunge the saw blade to start the cut. The guard lock is released by pushing in the direction of the arrow in the diagram. Either the hand holding the tool or work piece can be used, whichever is easier. c) After the cut has been finished and the tool switched off, ensure the guard lock has fully returned to its resting position. If not clean thoroughly with a soft brush. a) Grasp the handle firmly with the right hand so that it feels comfortable.
forwards along the line to be cut. (Never motion the tool backwards) h) Very little force should be used to feed the tool along the cut. Excess force will cause operator fatigue and excessive wear to the blade and tool. Excess force is also likely to cause the temperature cut-out to trip, resulting in delays. i) Ensure that the base plate is always held flat on the material being cut.
dust has been created, keep switched on for a few seconds extra to allow the dust to clear from within the tool. d) Cutting out tips: If the cut is to be covered, for example by a vent cover, the corners can be overlapped to ensure that the waste material is completely detached. If the cut out is to be seen, do not overlap the corners. In this circumstance, as the cutting blade is circular, the waste material will not be fully detached. The corners will therefore, require finishing with a knife.
The dust extract nozzle may block and require cleaning occasionally, especially if damp wood is being cut. Explanation of Symbols a) Unplug from mains supply and remove guard. (See Guard Removal Section) b) Clean thoroughly with a small soft brush, like a paint brush. Safety Blade Retaining Washer The blade is clamped in place using a special safety washer that is designed to slip if the blade jams. The result is that the motor slows down, sounds like it is labouring and the tool will stop cutting.
JML Guarantee This product is unconditionally guaranteed for one year against all defects of workmanship and materials. This guarantee does not affect your statutory rights. This warranty does not cover damage from negligence, misuse, abuse, accident, failure to follow operating instructions, commercial use, rental, repairs by an unauthorized facility, or products purchased, used, serviced or damaged outside of the United States. Distributed by JML USA, Inc.
