User's Manual

Exalt Communications Inc.
EX-2.4i Installation and Maintenance Manual
Page 26
MAN-002400, Revision 001
2005-12-01
Baud rate: 9600 bps
Parity: No
Data bits: 8
Stop bit: 1
Flow Control: No
Terminal Emulation: VT100
A standard serial cable (not a null modem cable) is required for connection between your device
and the Console port. See Appendix X for wiring detail.
Once connected and configured, press the return/enter key to get to a prompt. At the prompt,
enter ‘help’ or ‘?’ or ‘9’ or ‘menu’ to get to the root menu.
For a Telnet connection to the radio through either of the Ethernet ports, using Windows OS,
perform the following steps:
• Open a Command Prompt, or MS-DOS prompt (Start…Run..cmd)
• Enter the following at the command line of the command prompt window:
C:\>Telnet <IP Address>
Note: The default IP address of the EX-2.4i is 10.0.0.1
Note: You may reset the default address through serial CLI or by radio reset (as described
in section 4.1.3)
After entering this command, your command window should indicate: Connecting to
10.0.0.1 . . .
• When prompted, enter the administration level password
Note: The default administration password is ‘admin’ (no quotes, case sensitive)
Note: You may reset to the default administration password by radio reset (as described
in Section 4.1.3)
• At the prompt, enter ‘help’ or ‘?’ or ‘9’ or ‘menu’ to get to the root menu
4.5.2 CLI construction
The EX-2.4i utilizes three different methods for commands:
(1) Menu-driven structure
(2) Direct CLI command strings
(3) Direct CLI number sequences
The Menu-driven structure is easy-to-use, where simply typing a return/enter key, help or the
number 9, a display is provided, prompting the user with the acceptable commands at that point
in the menu structure.
The CLI command string is intended for users that become familiar with the CLI command
string, and this avoids the need to go through any menu structure, where direct commands can be
typed.