User Manual

Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 115
2007-06-25
Table 7 provides the standard factory defaults for the ‘-16’ models.
Table 7 Standard Factory Defaults (-16 Models)
Parameter EX-2.4i-16 EX-5i-16
Frequency 2441 MHz 5788 MHz
Transmit Power +7 dBm +4dBm
Link Distance <10 miles
Bandwidth 8 MHz
Mode Mode 1
TDD Frame Size 2ms
Ethernet Interfaces Enabled, 100/Full
AUX port NMS Access In-Band
T1/E1 Settings All Enabled, T1, B8ZS, AIS
There are several scenarios for using the DIP switches. Table 8 describes common
configurations and related applications.
Table 8 Common DIP Switch Applications
Application Switch Positions Comments
Reset all critical factory defaults 0xxxxxxx If the IP address and/or passwords are
forgotten or lost, use this setting and execute
the critical reset procedure (RMT button held
through boot cycle).
Reset complete factory defaults
except for IP information and
passwords
1x00xxxx If the IP address and/or passwords are already
reset or are known but the configuration of the
radio parameters is unknown, use this setting
to restore all parameters to factory defaults.
Execute the critical reset procedure with these
settings. If trying to establish a link, configure
one radio as Radio A, the other as Radio B
using position 2.
Configure the radio as Radio A
while resetting.
11xxxxxx Choose the desired reset function using
position 4. Reset one radio as Radio A with
position 2 up, so that a link can be established.