User Manual

Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 129
2007-06-25
– Directional flat panel: 28 dBi (~2'/61cm square)
Industry Canada (IC), Canada
This device complies with RSS-210 of Industry Canada. Operation is subject to the
following two conditions:
3. this device may not cause interference, and
4. this device must accept any interference, including interference that may cause
undesired operation of the device.
Antennas Supported in Canada
The EX-2.4i is designed to operate with the antennas listed in Table 10, which have a
maximum gain of 30.3 dBi. Antennas not included in the list or having a gain greater than
30.3dBi are prohibited for use with this device. The required antenna impedance is 50
Ohms.
The antenna associated with the EX-2.4i family shall be mounted in a location that is at
least 10 feet away from humans that may be subject to long-term or continuous exposure.
See Table 6 for Antenna Details.
The EX-5i family has been designed to operate with the antennas listed in Table 11
which have a maximum gain of 37.9 dBi. Antennas not included in the list or having a
gain greater than 37.9 dBi are prohibited for use with this device. The required antenna
impedance is 50 Ohms.
The antenna associated with the EX-5i family shall be mounted in a location that is at
least 10’/3m away from humans that may be subject to long-term or continuous exposure.
Important: Where required by regional regulations, DFS is enabled by the system keys
and cannot be disabled.
Canada Compliance
The EX-2.4i and EX-5i models operate under RSS-210 of Industry Canada regulations.
The EX-4.9i model operates under RSS-111 of Industry Canada regulations. Operation is
subject to the following conditions, unless express permission is granted by Industry
Canada to operate in a different manner:
• External amplifiers cannot be used to boost the power or to overcome transmission
system losses, unless the specific amplifier/cable/antenna combination is expressly
authorized by Industry Canada.
• Cross-border transmissions are expressly prohibited, except with written permission
from both Industry Canada and the governing body of the neighboring country (FCC
for USA)
• Only parabolic dish antennas or directional flat-panel antennas may be used. No other
types of antennas (omni-directional, yagi, and so on) are authorized. Parabolic dishes
of either grid or solid type are allowed. Maximum gain of each type of antenna
allowed is: