User Manual

Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 36
2007-06-25
• Front projection mount (front panel extended forward from the rack mounting
surface)
Figure 11 Front projection mount configuration
• Rear flush mount (rear panel even with the rack mounting surface)
• Rear projection mount (rear panel extended forward from the rack mounting surface)
Figure 12 Rear-mount locations
The rack mounting brackets accommodate identical mounting configurations as shown in
the previous figures, and can be mounted three different ways with respect to the vertical
orientation in the rack:
1. Projecting down, using one full rack space and half of the space below, and leaving
a half-space gap below.
2. Projecting up, using one full rack space and half of the space above, and leaving a
half-space gap above.
3. Centered within two spaces, with ¼ rack space gap above and below.
Two radios mounted in the same rack can be mounted in adjoining spaces, utilizing a
total of three rack spaces.
Note: Screws for attaching the radio to the telecom rack are not
provided; use the appropriate screw type that matches the equipment rack.
USE THESE BRACKET-MOUNTING HOLES FOR
REAR-FLUSH OR REAR-PROJECTION MOUNTING