User Manual

Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 53
2007-06-25
CLI Screens and Menus
Use CLI or Telnet when prompted, and enter the administration level login and password.
The default administration login is admin and password is password (or admin for early
firmware releases). It is recommended that the default administration password be reset
by performing a radio reset (see Reset to Critical Factory Settings
on page 44).
The serial port CLI and Telnet CLI are identical. Figure 17 shows the three menu choices
available after log in.
Figure 17 CLI main menu
Select 1 or 2 to display the Configuration or Status menus, respectively. Select 3 to exit
the CLI/Telnet session. The following selections can be made on all screens:
• 0 = back to previous screen
• 9 = help
• Ctrl+\ (control and backslash keys) = exit session
The following depicts the complete CLI tree structure:
1. Radio information
2. Configuration
a. Current IP settings
b. Current system configuration
c. Set IP address and mask (admin only)
d. Set IP default gateway (admin only)
e. Administration (admin only)
– System time and date
– System reboot
– Password
– File transfer
– File activation