User Manual

Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 86
2007-06-25
Figure 38 Diagnostic Charts page
Use the cursor to point to any spot on any of the three charts, and all three charts illustrate
the measurements taken for that time interval in the upper-left corner of each chart. The
time interval is indicated by T=(value). This is followed by the value of the measurement,
listing the highest value, lowest value and average value measured over that time interval.
For example, in Figure 38 the displayed time interval is hours, and the cursor is held at
the T=13 mark on the horizontal axis. The measurements shown indicate performance
from 13 hours ago. The high/low/average values shown on each chart are measurements
made across that specific one-hour interval.