User's Manual
Table Of Contents
- Legal Notice
- Open-Source License Information
- About this Document
- General Compliance and Safety
- Regulatory Notices
- EU WEEE
- EU RoHS
- Regulatory Notices (4.9GHz Model)
- Safety Notices
- Exalt Limited Hardware Warranty
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- CLI Screens and Menus
- Exalt Graphical User Interface (GUI)
- Quick-Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- File Transfer Page
- File Activation Page
- Simple Network Management Protocol (SNMP) Configuration
- Alarms Page
- Performance Page
- Event Log Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Reboot Page
- Manual Page
- Troubleshooting
- General Practices
- Typical Indications of Issues
- Improper RF Cable Termination
- Multipath Propagation
- RF Interference
- Path Obstruction
- Misaligned Antenna
- Faulty Antenna
- Improper Grounding
- Insufficient Link Margin
- Moisture in the Transmission System
- Physical Specifications
- Common System Specifications
- EX-2.4i System Specifications
- EX-4.9i System Specifications
- EX-5i System Specifications, 5.3 GHz Band
- EX-5i System Specifications, 5.4 GHz Band
- EX-5i System Specifications, 5.8 GHz Band
- Interfaces
- Back-to-back Bench Testing
- DC Coupler for Antenna Alignment
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Copyright Notices
- Index
Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 137
2007-04-15
Ethernet interface, 116
throughput settings, 83
Ethernet Interface Configuration page, 82
ETHERNET MAIN/AUX LED, 51
Event Log page, 97
ExaltCalc tool, 37, 105
External Alarm Inputs parameter, 81
external GPS source, 42
external loopback modes, 85
F
factory default settings, 56, 88
fade margin, 29, 109
features, 24, 27
File Activation page, 87, 90
File Transfer page, 87
file transfers, 87
files
activating stored, 90
default configuration file, 88
frame length. See TDD frame
frequency
center, 30
G
gateway (default), 89
Global Positioning System (GPS) kit, 40
GPS sync features, 38
grounding, 109
GUI
Administration Settings page, 76
Alarms page, 92
browsers supported, 68
description, 68
Diagnostic Charts page, 99
E1 Interface Configuration page, 84
Ethernet Interface Configuration page, 82
Event Log page, 97
File Activation page, 87, 90
File Transfer page, 87
IP address (default), 68
log in, 69
login privileges, 70
navigation panel, 72, 74
Performance page, 94
Radio A configuration, 68
Radio Information page, 75
Reboot page, 102
Spectrum Analyzer page, 101
summary status information, 73
System Configuration page, 78
T1 Interface Configuration page, 83
T1/E1 Configuration page, 83
H
hop, 31
hub, 42
I
interfaces
alarm, 116
Ethernet, 116
power, 117
RF, 116
serial console, 116
Sync (In/Out), 117
T1/E1, 116
interference, 95
interference profile, 29
Internal Fan alarm, 92
IP address, 89
IP address conflicts, 69
IP address subnet, 69
IP settings, 32
IP subnet, 66
IP subnet mask, 89
L
latency optimization, 27
LED indicators
ETHERNET MAIN/AUX, 51
LINK, 51
RADIO A, 51
RMT, 52
STATUS, 51
SYNC IN, 52
SYNC OUT, 52
system status (rear panel), 52
T1/E1, 52
License Key, 77
lightning arrestor, 29
lightning arrestors, 63
Line Build Out (LBO), 83
Line Code, 83
link, 29
orientation, 38
RF link testing, 32
synchronization, 38
Link Distance parameter, 81, 89
LINK LED, 51, 73
link margin, 109
Link Name parameter, 89
link parameters, 72
Link Security Key, 76
Link Security Key parameter, 89
login names, 70
login privileges, 70
loopback, 83, 84, 85
external (local), 85
external (remote), 85
internal, 85
M
master timing, 41
Maximum RSL field, 96
MIB files, 87