User's Manual
Table Of Contents
- Legal Notice
- Open-Source License Information
- About this Document
- General Compliance and Safety
- Regulatory Notices
- EU WEEE
- EU RoHS
- Regulatory Notices (4.9GHz Model)
- Safety Notices
- Exalt Limited Hardware Warranty
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- CLI Screens and Menus
- Exalt Graphical User Interface (GUI)
- Quick-Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- File Transfer Page
- File Activation Page
- Simple Network Management Protocol (SNMP) Configuration
- Alarms Page
- Performance Page
- Event Log Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Reboot Page
- Manual Page
- Troubleshooting
- General Practices
- Typical Indications of Issues
- Improper RF Cable Termination
- Multipath Propagation
- RF Interference
- Path Obstruction
- Misaligned Antenna
- Faulty Antenna
- Improper Grounding
- Insufficient Link Margin
- Moisture in the Transmission System
- Physical Specifications
- Common System Specifications
- EX-2.4i System Specifications
- EX-4.9i System Specifications
- EX-5i System Specifications, 5.3 GHz Band
- EX-5i System Specifications, 5.4 GHz Band
- EX-5i System Specifications, 5.8 GHz Band
- Interfaces
- Back-to-back Bench Testing
- DC Coupler for Antenna Alignment
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Copyright Notices
- Index
Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 49
2007-04-15
Table or Rack Shelf Mounting the System
Affix rubber feet or adhesive-backed non-slip pads (not included) near the corners of the
unit along the bottom panel when mounting on a table or a rack shelf. These pads help
keep the radio stable on a wooden or metal surface.
Caution: In many areas, it is necessary to strap the equipment to a
table or rack shelf if mounting in this manner. In case of earthquake or
other shock or vibration, or an accidental pull of a cable, the unit should be
secured from falling. It may also be necessary to secure the AC adapter, if
it is used.
Radio Ports and Indicators
This section provides a brief overview of the connectors, controls, and indicators on the
device. Details about each item are in other sections of this document.
The EX-2.4i front panel is shown in
Figure 13. The EX-4.9i and EX-5i front panels are
identical, except for the model number shown in the upper-right corner.
Figure 13 Front panel (EX-2.4i, EX-4.9i or EX-5i)
The EX-2.4i-16 front panel is shown in Figure 14. The EX-5i-16 front panel is identical,
except for the model number shown in the upper-right corner.
Figure 14 Front panel (EX-2.4i-16 or EX-5i-16)
Connector Overview
The primary user interfaces are shown in Figure 15. Table 4 provides details of the front
panel connectors of all radios. Detailed pin structures for each connector are in Interface
Connections
on page 123.