User's Manual
Table Of Contents
- Legal Notice
- Open-Source License Information
- About this Document
- General Compliance and Safety
- Regulatory Notices
- EU WEEE
- EU RoHS
- Regulatory Notices (4.9GHz Model)
- Safety Notices
- Exalt Limited Hardware Warranty
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- CLI Screens and Menus
- Exalt Graphical User Interface (GUI)
- Quick-Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- File Transfer Page
- File Activation Page
- Simple Network Management Protocol (SNMP) Configuration
- Alarms Page
- Performance Page
- Event Log Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Reboot Page
- Manual Page
- Troubleshooting
- General Practices
- Typical Indications of Issues
- Improper RF Cable Termination
- Multipath Propagation
- RF Interference
- Path Obstruction
- Misaligned Antenna
- Faulty Antenna
- Improper Grounding
- Insufficient Link Margin
- Moisture in the Transmission System
- Physical Specifications
- Common System Specifications
- EX-2.4i System Specifications
- EX-4.9i System Specifications
- EX-5i System Specifications, 5.3 GHz Band
- EX-5i System Specifications, 5.4 GHz Band
- EX-5i System Specifications, 5.8 GHz Band
- Interfaces
- Back-to-back Bench Testing
- DC Coupler for Antenna Alignment
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Copyright Notices
- Index
Exalt Communications, Inc.
Exalt i-Series Installation and Management Guide
5000001 87
2007-04-15
File Transfer Page
This page allows the administrator to upload and download files to and from the radio.
Two types of files can be uploaded: configuration and radio firmware. When uploading
Configuration Files, current configuration parameters are immediately overwritten,
and the unit automatically reboots. When uploading radio firmware files, the file is
placed into reserve memory space. After the new radio firmware file uploads, use the File
Activation page to enable the files (see File Activation Page on page 90).
Up to three types of files can be downloaded: configuration, radio firmware, and MIB.
The MIB file refers to the Management Information Base related to the Simple Network
Management Protocol (SNMP) function, and is only available on models which support
SNMP. See
Simple Network Management Protocol (SNMP) on page 91 for more
information.
Note: Check the File Activation page before uploading radio firmware
files. New file uploads overwrite the secondary file location. If important
files reside in the primary or secondary file location, download them
before uploading the new files. Only the active radio firmware file can be
downloaded. Therefore, to download the reserve file, it must first be
activated (using the Swap button). See File Activation Page on page 90.
Figure 32 File Transfer Page